rover 200 alloy wheels

rover 200 alloy wheels

When trouble-shoot a Rover 200, first go with the fundamentals. These simple trials can work for any engine. All engines need three basic things to run fuel, spark and air. These simple things can cause your Rover 200 to not go up or run poorly.

rover 200 maintenance manual

First start off with the fuel Remove the hose off the tank and make sure the fuel is flowing properly. Some bikes will have to turn the fuel selector to prime, not on, or fuel will not flow.

rover 200 over revving

Take a flashlight and look down into the tank, is the fuel varnished or is there dirt in the tank? Older Rover 200s had a problem with tanks oxidizing inside and would plug the screen up inside the tank. Fuel delivery may still be a problem but we will come back to that later.

rover 200 front wing removal

Next Remove the spark plugs, you may need to Remove the tank to reach them. Inspect every spark plug as you take them out. All the spark plugs should look the same. If a plug looks white colored, that piston chamber may be (lean) and not getting enough fuel.

rover 200 engines

If you have a plug that looks wet and black, that cylinder may getting too much fuel (rich) or not sparking good. Withdraw all the spark plugs and snap the plugs back into their wires.

rover 200\/25

Set the spark plugs on the engine so that they can ground themselves. Crank the motorcycle over and watch the plugs for sparks, preferably somewhere dark. Make sure you look at all the plugs to make sure they are all sparking.

rover 200 clutch

If one spark looks down check the wire and plug, if old or worn replace them. If their is no spark the coil may be bad.If you have any test equipment such as an ohm meter, you can find out what the resistance reading should be for your bikes coils.

This way you will know for sure if the coils are o.k. If the ignition system looks fine move on to the carburetors. First, if the bike has not been maintained recently (a problem in itself) make sure the carbs are synchronized. To do this you need a vacuum gauge made for this. Remove the small rubber plug located between the carbs and the cylinder.

rover 200 alarm bypass

Attach the gauge and take the readings from for each one piston chamber. Replace the caps when not measuring or it won’t run right. Correct the throttle screw or linkage for that carb until they all read close to one another. Refer back to inspecting the spark plugs. If one piston chamber looked lean or rich check all hoses for cracks and air leaks. If the Rover 200 has not been run in awhile the carbs may be (gummed up). Remove the float bowl off the bottom of the carb.

rover 200 immobiliser

Look in the bowl for dark varnish looking gas. If the fuel looks dark you will probably have to Withdraw the pilot and main jets and cautiously run a wire through the center hole to clean them out. Be careful to not bend the float as the peak needs to be correct to run well As Well. Check that the small needle attached to the float between the pivot point, is moving up and down.

rover 200 problems

If it doesn’t move smoothly the carb will not fill up with gas or will run low as your driving down the road. Make sure you check the battery As Well, if they become weak the ignition system won’t have enough force to keep the bike running smoothly. If you still haven’t found anything make sure you valve lash has been checked at the correct mileage intervals. If not this can cause many problems with the way it runs.

rover 200 clutch problem

As Well you can screw a compression gauge into the spark plug holes and check that they are within 5% 10% of for each one other. If one is way down you have a serious problem either with the pistons, bore or valves. This should be a good go to finding a general trouble with your Rover 200.

FREE SHIPPING WORLDWIDE
CD VERSION
Only £7.99


Rover200 Common Faults Resolved With This Service Manual – Get It Now. = ROVER 200 Manual

Advertisements

Leave a comment

Filed under Manuals

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )

Connecting to %s