Suzuki VZR1800 Boulevard Manual
When troubleshooting a VZR1800, first start with the fundamentals. These simple trials can work for any engine. All engines need three basic things to run fuel, spark and air. These simple things can cause your Suzuki VZR1800 to not start up or run poorly.
First start off with the fuel Withdraw the hose off the tank and make sure the fuel is flowing properly. Some bikes will have to turn the fuel selector to prime, not on, or fuel will not flow.
suzuki vzr1800 test
Take a torch and look down into the tank, is the fuel finished or is there dirt in the tank? Older Suzuki VZR1800s had a trouble with tanks rusting within and would plug the screen up inside the tank. Fuel delivery may still be a trouble but we will come back to that later.
Next Remove the spark plugs, you may need to Remove the tank to reach them. Inspect every spark plug as you take them out. All the spark plugs should look the same. If a plug looks white colored, that cylinder may be (lean) and not getting enough fuel.
If you have a plug that looks wet and black, that cylinder may getting too much fuel (rich) or not sparking good. Withdraw all the spark plugs and snap the plugs back into their wires.
Set the spark plugs on the engine so that they can ground themselves. Crank the bike over and observe the plugs for sparks, preferably somewhere dark. Make sure you look at all the plugs to make sure they are all sparking.
suzuki vzr1800 oem parts
If one spark looks down check the wire and plug, if old or worn replace them. If their is no spark the coil may be bad.If you have any test equipment such as an ohm meter, you can find out what the resistance reading should be for your bikes coils.
This way you will know for sure if the coils are o.k. If the ignition system looks fine move on to the carburetors. First, if the motorcycle has not been kept recently (a problem in itself) make sure the carbs are synchronized. To do this you need a vacuum gauge made for this. Remove the small rubber plug located between the carbs and the cylinder.
Attach the gauge and take the readings from each piston chamber. Replace the caps when not measuring or it won’t run right. Adjust the throttle screw or linkage for that carb until they all read close to one another. Refer back to inspecting the spark plugs. If one cylinder looked lean or rich check all hoses for cracks and air leaks. If the VZR1800 has not been run in awhile the carbs may be (gummed up). Remove the float bowl off the bottom of the carb.
Look in the bowl for dark varnish looking gas. If the fuel looks dark you will probably have to Withdraw the pilot and main jets and cautiously run a wire through the center hole to clean them out. Be careful to not bend the float as the height needs to be correct to run well As Well. Check that the small needle connected to the float ‘tween the pivot point, is moving up and down.
suzuki vzr1800 specs
If it doesn’t move smoothly the carb will not fill up with gas or will run low as your driving down the road. Make sure you check the battery As Well, if they become weak the ignition system won’t have enough power to keep the bike running swimmingly. If you still haven’t found anything make sure you valve lash has been checked at the correct mileage intervals. If not this can cause many problems with the way it works.
As Well you can screw a compression gauge into the spark plug holes and check that they are within 5% 10% of each other. If one is way down you have a serious problem either with the pistons, bore or valves. This should be a good start to getting a general problem with your Suzuki VZR1800.
DOWNLOAD THE LATEST suzuki vzr1800 service manual = suzuki vzr1800 service manual